je.st
news
Tag: contactor
Hybrid Contactor supports high-frequency testing.
2016-03-15 13:31:04| Industrial Newsroom - All News for Today
Used for testing high frequency semiconductors in high-volume production, mmWave Contactor combines traditional spring probe architecture for low frequency and power I/O’s with cantilever solution for peripheral high frequency transceiver I/O’s. Keeping interface from test equipment to device as short as possible while minimizing number of transitions enables broadband performance from DC to 81 GHz to be maintained. Typical applications include automotive radar, WiGig, and 5G backhaul devices.
Tags: testing
supports
hybrid
contactor
Cohu Introduces RF Scrub Test Contactor
2016-03-08 06:05:12| rfglobalnet News Articles
Cohu, Inc.a leading supplier of semiconductor equipment announced recently the introduction of RF Scrub contactor for testing a wide spectrum of devices with frequencies up to 33 GHz.
Tags: test
introduces
scrub
contactor
High Current Contactor is intended for strip test.
2015-09-11 14:31:07| Industrial Newsroom - All News for Today
Tested to provide >99% first pass yield and contact pin life span of >1 million insertions, Multitest High Current Strip Contactor addresses high power carrying capability and limited space in high parallel test set up. This high power Kelvin contactor for strip test is based on ecoAmp Cantilever design and optimized for electrical performance and temperature accuracy.
Tags: high
current
test
intended
New 8in x 20in Stainless Steel Membrane Contactor for Dissolved Gas Control Targets Moderate Liquid Process Flow Rates
2014-04-10 18:08:00| Power Technology
Membrana-Charlotte has introduced a new 8in x 20in stainless steel Liqui-Cel Membrane Contactor to its portfolio of dissolved gas control products.
Tags: control
process
rates
flow
Elastomer Contactor features fully customizable design.
2014-01-30 14:33:45| Industrial Newsroom - All News for Today
Compatible with both pick-and-place and solder reflow processes, Elastech® INVISIPIN™ features DC contact resistance of less than 25 mΩ and bandwidth of 1 dB at greater than 50 GHz. Low Contact Force version, rated 8 gmf per pin at less than 30 mΩ, uses extremely low force, making it suited for board-to-board interconnect applications where mating cycles will not exceed 2,500. High insertion version requires more force, but exceeds 100,000 mating cycles. This story is related to the following:Electronic Components and Devices Sponsored by: Globtek Inc. - Your Power Partner...For Over 20 Years!Search for suppliers of: Board To Board Connectors
Tags: design
features
fully
customizable