je.st
news
Tag: canopen
Subsea LVDT Linear Position Sensor has CiA 443 CANopen interface.
2015-10-01 14:31:08| Industrial Newsroom - All News for Today
With CiA® 443 CANopen communication interface for use on subsea trees in offshore oil drilling, SSI Series provides feedback on valves in monitoring and controlling their status as part of subsea control module. Sensors are encased in Inconel 625 to withstand deep sea environments with pressures up to 5,000 psi. Levels of nickel, chromium, and molybdenum promote protection against corrosion and meet service life requirements of at least 20 years even if fully exposed to seawater.
Tags: position
interface
linear
sensor
Macro Sensors Subsea LVDT Linear Position Sensor Now Compliant With CiA 443 CANopen Profile for Use on Subsea Trees
2015-09-23 12:31:14| Industrial Newsroom - All News for Today
Macro Sensors now offers its SSI Series of Subsea LVDT Linear Position Sensors with the CiA 443 CANopen communication interface mandated for use on subsea trees (a.k.a. christmas trees) used in offshore oil drilling. The term "christmas tree" refers to the assembly of valves, sensors and controllers and other...
Tags: profile
position
linear
trees
Brushless DC Motors offer CANopen networking capabilities.
2015-08-31 14:31:07| Industrial Newsroom - All News for Today
With CANopen interface, up to 127 Brushless DC Motors can be connected with single, shielded 2-wire cable. Data may be transmitted at speeds up to 125 kBd at distances over 550 yards. At lower baud rates, transmission distance can exceed 3 miles, making communications flexible to virtually any location. Able to withstand up to 80 Vdc regenerative energy, CANopen-enabled motors utilize 2 safety inputs to cut down power in motor even if microprocessor has failed.
Tags: offer
networking
capabilities
motors
Finger Operated Joysticks offer CANbus and CANopen options.
2015-05-12 14:31:07| Industrial Newsroom - All News for Today
Featuring contactless Hall effect sensing, HF Series is available with up to 3 proportional axis and 2 momentary pushbuttons. IP67-rated units measure just 40 mm below panel, making them suitable for vehicles where ergonomics and operator comfort are paramount. Available with up to 4 default addresses, CANbus J1939 option may be specified with Baud rate of 125 kbit/s, 250 kbit/s, 500 kbit/s, or 1 Mbit/s and cycle time of either 50 ms or 15 ms.
Tags: options
offer
operated
finger
AC and DC Actuators enhance motion control with CANopen support.
2013-12-10 14:32:26| Industrial Newsroom - All News for Today
Available with CANopen communication protocol, Tritex™ II AC and Tritex II DC actuators can serve as integral part of control architecture or machine control processes. These actuators are intended to perform as Slave with CANopen Master, and system setup is accomplished with Expert software using RS485 port. Connections for CANopen are offered with either M12 connector or wired directly to terminal strip on connection board with 75, 90, and 115 mm frame sizes. This story is related to the following:Linear Actuators |
Tags: with
support
control
motion