je.st
news
Tag: conductive
Conductive Adhesive targets back contact solar modules.
2013-05-08 14:30:59| Industrial Newsroom - All News for Today
Designed to make contact from vias or other conductors on crystalline silicon solar cells to back contact sheet, DB-1588-2 Conductive Adhesive is stress absorbing to withstand rigors of thermal cycling. Product features optimal conductive stability to back contact metallizations during damp heat exposure, and is designed to cure through encapsulant lamination and cure process. This story is related to the following:Electrically Conductive Adhesives
Tags: contact
back
modules
targets
Conductive Die Attach Adhesive supports small die and LEDs.
2013-05-08 14:30:59| Industrial Newsroom - All News for Today
Featuring high glass transition temperature to facilitate wire bonding, CA-105 Die Attach Adhesive is suitable for attaching LEDs and other small semiconductor die to silver and copper lead frames. Product has dispensing open time greater than 24 hours, measured as 25% increase in viscosity, while maintaining optimized rheology for pin transfer or needle dispensing. This story is related to the following:Die Attached Adhesives |
Tags: die
small
supports
attach
AODD Pumps Include Electrically Conductive PTFE Diaphragms
2013-04-18 06:00:00| Chemical Processing
Almatecs E-Series Plastic air-operated double-diaphragm (AODD) pumps have been upgraded with electrically conductive PTFE (polytetrafluoroethylene) diaphragms to provide safer transfer of chemicals while avoiding dangerous electrostatic discharge.
Tags: include
pumps
electrically
conductive
Electrically Conductive Adhesives suit automotive applications.
2013-04-16 18:42:10| Industrial Newsroom - All News for Today
Designed to address harsh environmental conditions, Loctite Ablestik ICP 4000 Series withstands operating temperatures up to 200°C. Materials are single component, silver-filled, silicone-based adhesives with flexibility that allows for compensation of common CTE mismatches and ability to survive in extreme vibration over extended periods of time. Adhesives also exhibit very low outgassing and bleed during cure. This story is related to the following:Chemical Processing and Waste ManagementSearch for suppliers of: Electrically Conductive Adhesives |
Tags: applications
automotive
suit
electrically
Electrically Conductive Coating serves applications to 1,700°F.
2013-04-09 14:39:28| Industrial Newsroom - All News for Today
Suited for use in production of electronic and high vacuum components, Pyro-Duct™ 597-C is formulated using high purity silver flake with D50 particle size of less than 20 microns. All constituents are electrically and thermally conductive, and volume resistivity is 0.0002 Ω-cm at room temperature. Applied by brush, dipping, or spray gun, this single-component system adheres to ceramic and glass substrates and dries at room temperature in ~1 hr. Full cure takes 30 min at 480°F. This story is related to the following:High Temperature Coatings | Conductive Coatings
Tags: applications
serves
coating
electrically
Sites : [14] [15] [16] [17] [18] [19] [20] [21] [22] [23] [24] [25] next »