je.st
news
Slitting/Milling Tool Holders feature taper integrated design.
2013-01-31 14:32:36| Industrial Newsroom - All News for Today
Designed to direct mount to any ER 16 collet holder using standard ER nuts, Ti-Loc SwissClamp Slitting and Milling Tool Holders extend micro endmills closer to workpiece and eliminate inaccuracies caused by tolerance stacking. Typical TIR is held to .0002 in. or better. Arbors are available for 5 mm, 8 mm, ¼ in., and 5/16 in. ID saws, and Micro Endmills Extensions will be available to hold 3 mm, 4 mm, 1/8 in., and 3/16 in. shanks. Installation requires twist and snap into any ER clamping nut. This story is related to the following:Machinery and Machining Tools Sponsored by: Haas Automation, Inc. - Category Sponsor AdSearch for suppliers of: End Mill Tool Holders |
Tags: design
feature
tool
integrated
Category:Industrial Goods and Services