je.st
news
Tag: generators signal
Waveform Generators deliver optimized signal accuracy.
2014-03-13 13:31:08| Industrial Newsroom - All News for Today
Available in four 1- and 2-channel models with Trueform signal-generation technology, 33600A Series generates waveforms up to 120 MHz at 1 GSa/s sampling rate with less than 1 ps jitter. Units offer total harmonic distortion of less than 0.03% and non-harmonic spurs below -75 dBc, enabling generation of clean signals for accurate results. Rise and fall times of 3 ns allow users to accurately set trigger points, while low voltage range of 1 mVpp enables output changes down to 1 µV. This story is related to the following:Waveform Generators |
Tags: accuracy
signal
deliver
optimized
Signal Generators optimize phase noise performance.
2014-02-25 14:31:40| Industrial Newsroom - All News for Today
At carrier frequency of 1 GHz, S-Series provides -140 dBc/Hz phase noise at frequency offsets from 100 kHz to 1 MHz, while maintaining frequency settling time of 100 µs. Model SGD is further optimized by addition of wideband analog modulation and Arbitrary Waveform Generator sequence mode. Analog modulation provides internal AM, FM, and phase modulation, while ARB sequence mode allows user to set up sequence of waveforms generated in ARB to provide rapid test sequence. This story is related to the following:Signal Generators |
Tags: performance
phase
signal
noise
Aeroflex S-Series Signal Generators Improve Phase Noise Performance
2014-02-14 04:13:55| rfglobalnet News Articles
Aeroflex Limited, a wholly owned subsidiary of Aeroflex Holding Corp., has enhanced its S-Series signal generators (SGA and SGD) with improved phase noise and better RF level accuracy.
Tags: performance
improve
phase
signal
RF Signal Generators: DSG3000 Series Datasheet
2014-02-11 15:14:12| rfglobalnet Downloads
The DSG3000 series offers standard AM/FM/ØM analog modulation, as well as options for I/Q modulation and I/Q baseband output. The RF signal generator is available with maximum frequencies of either 3 GHz or 6 GHz. Featuring a high signal purity with phase noise measuring <-110dBc/Hz@20kHz (typical) and a wide output range of -130dBm to +13dBm, the DSG3000 RF signal generator has standard pulse modulation with an on/off ratio of up to 80dB, with optional pulse train generator available. The DSG3000 series also has an amplitude accuracy of <0.5dB (typical).
Tags: series
signal
generators
datasheet
Microwave Analog Signal Generators feature low phase noise.
2013-12-09 14:28:56| Industrial Newsroom - All News for Today
Featuring 2 RU design, Model N5183B MXG features phase noise of less than -124 dBc/Hz and -75 dBc spurious, enabling module- and system-level testing up to 40 GHz. Unit also accelerates calibration of complex systems with switching speed of less than 600 µs. Model N5173B EXG, combining output power of +20 dBm at 20 GHz with low harmonics of less than -55 dBc, is suited for characterization of broadband microwave components such as filters and amplifiers. This story is related to the following:Electrical Equipment and Systems Sponsored by: Globtek Inc. - MOBILE BANNER ADSearch for suppliers of: Signal Generators |
Tags: low
feature
phase
signal