je.st

Home › incorporating

Tag: incorporating

A Step Change in Electronics Thermal Design: Incorporating ADE and MDA Design Flows

2015-05-04 17:12:09| rfglobalnet Downloads

The main source of heat in electronic equipment is their semiconductor chips, and the temperature sensitivities of these chips presents a challenge in designing cooling mechanisms. Overheating causes the chips to prematurely fail—and failure of only one chip can disable the entire equipment, the higher the chip temperature, the earlier and more certain the failure. As functionality has increased, the associated heat dissipation has escalated to the extent that it is recognized as a potential limitation on the pace of electronics development. Appropriate cooling strategies are needed to prevent overheating, and failure, of critical components.

Tags: design change electronics step

3 Keys To Incorporating Micro Ingredients Into Product Mixing

2015-04-09 18:38:41| foodingredientsonline Home Page

Mixing minor and micro ingredients into batches can often be a challenge. If not properly incorporated into the carrier mix, the end product’s desired quality will likely fall short of expectations. However, by examining a few important factors, mixed food products will live up to high standards of quality.

Tags: product micro keys ingredients

Vetroplas launches new tube range incorporating in-mould labelling technology

2015-01-20 01:00:00| Packaging Gateway

Cosmetics and personal care packaging specialist Vetroplas has expanded its product portfolio with the introduction of a new range of tubes using in-mould labelling technology in the UK.

Tags: range technology tube incorporating