je.st
news
Tag: astm
Loop Tack Tester measures adhesive strength per ASTM standard.
2013-12-20 14:28:24| Industrial Newsroom - All News for Today
Used with CT3 Texture Analyzer, which operates in both compression and tension modes, Model TA-LTT tests adhesive strength of materials per ASTM D2979. Sample is adhered to slide that is placed in bottom fixture. Top of sample is then gripped by upper clamp and CT3 Tester applies tension, measuring force required to break adhesive bond. Offering range of test modes, TexturePro CT Software generates detailed analytical data for each test and produces statistical reports over multiple samples. This story is related to the following:Sensors, Monitors and TransducersSearch for suppliers of: Compression Testers
Tags: standard
measures
strength
loop
Papers on Total Joint Replacement Devices Invited for ASTM International Symposium
2013-12-19 06:00:00| Industrial Newsroom - All News for Today
Sponsored by ASTM International Committee F04 on Medical and Surgical Materials and Devices, symposium on Modularity and Tapers in Total Joint Replacement Devices will take place Nov 10, 2014 at the Sheraton New Orleans. Purpose of symposium is to provide forum for consensus development and scientific exchange on needs for characterization and standardized testing related to modularity and tapers used in total joint replacement devices. This story is related to the following:Trade Associations
Tags: total
international
devices
papers
Papers Invited for ASTM International Symposium on Wildland-Urban Interface Fires
2013-12-19 06:00:00| Industrial Newsroom - All News for Today
Papers are invited for symposium on Structure Ignition in Wildland-Urban Interface Fires, to be held June 18-19, 2015. Of particular interest are research studies that may provide scientific basis for cost-effective building codes/standards as well as retrofit strategies to reduce structures lost in fires. These could include post-fire/case studies; experimental structure ignition and ember accumulation studies; WUI exposure computer modeling studies, and studies evaluating mitigation ...This story is related to the following:Trade Associations
Tags: international
interface
papers
invited
ASTM Plastic Piping Systems Committee Developing Proposed Standard for Fluid Composite ...
2013-12-18 06:00:00| Industrial Newsroom - All News for Today
ASTM WK44033, Specification for Fluid Composite Transfer Pipe and Fittings, will cover requirements and test methods for a new type of pipe used for general water transport at industrial, mining, and oil/gas field applications for well-site transmission of influent, fracking flowback, and wastewater, at up to 250 psi working pressures. Once approved, it will be used or referenced by federal and state regulatory agencies to maintain high quality, leak-free pipe installations. This story is related to the following:Trade Associations
Tags: standard
systems
committee
proposed
ASTM Workshop to address additives in biomedical polymers.
2013-12-17 14:31:32| Industrial Newsroom - All News for Today
Presentations are invited for workshop on the Use of Additives in Biomedical Polymers to be held May 6, 2014. Workshop aims to elicit discussion on benefits, potential hazards, testing, regulatory considerations, and opportunities for standard activities related to intentionally incorporated additives in biomedical polymers. Some topics for abstract submissions include: colorants; radiopacifiers; elutables, extractables, and leachables; radiolabels; nanomaterials; and failure mechanisms. This story is related to the following:Trade Associations
Tags: address
workshop
biomedical
polymers
Sites : [39] [40] [41] [42] [43] [44] [45] [46] [47] [48] [49] [50] [51] [52] [53] [54] [55] [56] [57] [58] next »