je.st
news
Tag: noise
17-27 GHz Low Noise Amplifier: CMD163
2016-02-03 11:18:25| rfglobalnet Products
Custom MMIC introduces the CMD163 as a high dynamic range GaAs low noise amplifier (LNA) designed for military, space, and communications systems where small size and high linearity are required. This device delivers greater than 24 dB of gain with a corresponding output 1 dB compression point of +19 dBm and a noise figure of 1.3 dB. It is optimized for 21 GHz operation.
NW District Sewer Replacement Project - Proposed Change Noise Variance
2016-02-02 17:57:03| PortlandOnline
Environmental Services has completed design of a project to replace about 8,000 feet of sewer pipe that is in poor condition. The pipes range in size from eight to 36 inches. The project will increase sewer system capacity and help prevent sewer backups in basements. The project is anticipated to start this summer and the entire project timeline is 18 months.
Tags: change
project
district
proposed
02.03.16 -- Phase Noise Test Systems; Low Loss RF Cable Assemblies; Vibration Tolerant TCXO
2016-02-02 00:17:33| rfglobalnet News Articles
02/03/16RF Globalnet Newsletter
Fixed Frequency Synthesizer features ultra low phase noise.
2016-02-01 14:31:06| Industrial Newsroom - All News for Today
Operating at 6,265 MHz with external 100 MHz reference oscillator, Model SFS6265A-LF features typical phase noise of -89 and -90 dBc/Hz at 1 kHz and 10 kHz offsets, respectively. Device delivers typical output power of +3 dBm while operating off VCO voltage supply of 5 Vdc and drawing 35 mA, and phase locked loop voltage of 3 Vdc while drawing 11 mA. Housed in 0.6 x 0.6 x 0.13 in. PLL-V12N package, synthesizer features 2nd harmonic suppression of -20 dBc and spurious suppression of -65 dBc.
Tags: low
features
fixed
phase
Hard Flooring Membrane dampens impacts and noise.
2016-01-29 14:31:06| Industrial Newsroom - All News for Today
Designed for use under thin-bed adhesives for ceramic tile, stone, and other hard surface installations, FRACTURE BAN™ eliminates transmission of stresses from substrate while dampening transmission of impact (ANSI A118.12) and air-borne noise (ANSI A118.13) through floor to room below. This reinforced, pliable, peel-and-stick membrane, made from hot-applied polymer modified asphaltic adhesive coated on 100% non-woven polyester, acts as anti-fracture and acoustical underlayment system.
Tags: hard
noise
membrane
impacts
Sites : [21] [22] [23] [24] [25] [26] [27] [28] [29] [30] [31] [32] [33] [34] [35] [36] [37] [38] [39] [40] next »