je.st

Home › specification

Tag: specification

TX/RX Controller and PHY IP support HDMI 2.0 specification.

2013-09-11 14:30:55| Industrial Newsroom - All News for Today

With aggregate bandwidth up to 18 Gbps, DesignWare® HDMI 2.0 IP enables 4K x 2K resolution at 60 Hz frame rate in deep color mode to provide flickerless, ultra high-definition viewing experience. Ability to scramble transition-minimized differential signaling data above 3.4 Gbps adds to viewing experience by minimizing EMI that occurs in 8b/10b coded data streams. Analog front end supports pre-emphasis and adaptive equalization for optimal signal integrity across cables lengths 100+ ft. This story is related to the following:Controls and ControllersSearch for suppliers of: Communications Controllers

Tags: support controller specification hdmi

Thermally Conductive Two Component Silicone Meets UL 94V-0 Specification for Flame Retardancy

2013-09-11 06:00:00| Industrial Newsroom - All News for Today

In addition to typical silicone properties such as flexibility and high temperature resistance, Master Bond MasterSil 156 passes the rigorous UL 94V-0 tests for flame retardancy. This two part silicone system is addition cured and does not require exposure to air for complete cross-linking. It has a convenient one to one mix ratio by weight and will not outgas while curing.<br /> <br /> Formulated for potting, encapsulation and sealing applications, MasterSil 156 is a competent electrical ...This story is related to the following:Potting Compounds | Encapsulation Compounds |

Tags: component meets flame specification

HDMI Forum releases Version 2.0 of the HDMI specification

2013-09-04 07:30:31| Digital TV News

HDMI Forum has announced the release of Version 2.0 of the HDMI Specification. The update offers increased bandwidth to support new features such as 4K@50/60 (2160p); 32 audio channels; as well as dynamic auto lip-sync and extensions to CEC.

Tags: forum version releases specification

Test Hats - General Specification Brochure

2013-08-29 12:14:55| rfglobalnet Downloads

Test hats enable communication while containing the RF energy from an antenna. Haigh-Farr test hats are constructed out of a solid aluminum, one-piece case with a conductive EMI gasket where the hat is in contact with the ground plaine and the antenna. This provides a tight EMI seal, minimizing RF leakage, typically to -80 dB or lower.

Tags: general test brochure hats